Can you provide full gear measurement charts (profile/lead/pitch), not just pass/fail results?
- Share
- Issue Time
- Apr 14,2026
Yes. If required, we can provide full gear measurement charts—including tooth profile, lead, and pitch—not just pass/fail. The report scope is confirmed during quotation (sample stage vs mass production, and which parameters are critical).
What you’ll receive
Depending on your requirement, we can provide:
1. Tooth profile chart
2. Tooth lead/helix chart
3. Pitch / spacing results
4. Runout / span over pins (as applicable)
5. Summary judgment (pass/fail) with tolerances referenced
What affects report availability
√ Drawing references/standard (ISO/DIN/AGMA) and tolerance definition
√ Whether it’s FAI/sample approval or routine batch release
√ Required sampling plan (per part / per batch / per shift)
√ Confidentiality level (redaction needed)
How we make reports useful
We align charts to your functional datums and critical characteristics so you can see:
1. Where the deviation occurs (shape vs slope)
2. Whether it’s stable or drifting (process consistency)
3. What the risk is for noise/backlash/life (when relevant)
Quick table
| Report type | What it shows | Typical use |
| Profile chart | involute deviation | mesh quality / noise |
Lead chart | helix/lead deviation | contact pattern / load |
Pitch results | spacing deviation | smoothness / transmission |